Positive and negative roughness according to local differences between dem surface and 3d reference planes
Por:
Parrot J.-F., Ramírez-Núñez C.
Publicada:
1 ene 2021
Resumen:
The irregularities of the earth's surface are quantified by means of roughness measurements using Digital Elevation Models (DEM's). This article presents a roughness measurement method that is based on the calculation of the difference of altitude existing between a plane passing through the centre of a moving window and the altitude of the DEM surface inside this window. This method differs from the measure of the standard deviation and best fit plane, in the sense that it considers all difference values, positives or negatives. The measurement is done in a 3 × 3 or a 5 × 5 moving window and contemplates inside this window the plane which passes through the centre of the window and the highest pixel located in the border or perimeter of this window. According to the 3D configuration of the DEM surface inside the moving window, the sum of all the differences is positive or negative, allowing to discriminate the local morphology independently of the global roughness. The roughness variable which distinguishes negative and positive values allows to classify accurately landscape units such as watersheds, riverbeds, volcanic assemblages as well as landforms associated with tectonic structures. © 2021 Copernicus GmbH. All rights reserved.
Filiaciones:
Parrot J.-F.:
Laboratorio de Análisis Geoespacial (LAGE), Instituto de Geografía, UNAM, Ciudad de México, Mexico
Ramírez-Núñez C.:
ENCiT, UNAM, Ciudad de México, Mexico
All Open Access; Gold
|