Electrospun polylactic acid non-woven mats incorporating silver nanoparticles
Por:
Vargas-Villagran, H, Romo-Uribe, A, Teran-Salgado, E, Dominguez-Diaz, M, Flores, A
Publicada:
1 sep 2014
Resumen:
This research is focused on the influence of silver nanoparticles (AgNPs) on the spinnability, morphology and wetting properties of electrospun polylactic acid (PLA) non-woven mats. PLA was electrospun from a chloroform solution (4.7 % g/g) and a filament and beads morphology was obtained, the filaments having an average diameter of 1.25 µm. Interestingly, water contact angle measurements showed a contact angle of ? = 81°, an improvement relative to as-cast film which exhibited a contact angle of ? = 54°. When AgNP, of ca. 12 nm size, were incorporated at 1 % g/g relative to PLA weight, to the 4.7 % PLA-chloroform solution, and electrospun, the filaments diameter was greatly reduced to an average of 0.65 µm, and the density of polymer beads was also reduced. It is believed that the electric conductivity of silver enhanced the spinnability of the polymer solution. Strikingly, water contact angle measurements showed that the PLA/AgNP mats exhibited an angle as high ? = 134°. Increasing the solution concentration to 6.7 % g/g still produced a beads-and-filament morphology, but with larger filament diameters, probably due to an increase in solution viscosity. When AgNP were added (again at 1 % g/g relative to PLA weight), the occurrence of beads diminished and the average filament diameter decreased confirming the enhancement in spinnability by the AgNPs. Moreover, contact angles remained above 110° suggesting that the overall morphology is key to PLA's mats hydrophobic behavior and not only filament diameter. Finally, the non-woven mats were rather amorphous, as revealed by differential scanning calorimetry and X-ray scattering, due presumably to the quenching process associated with the electrospinning process. © 2014 Springer-Verlag Berlin Heidelberg.
Filiaciones:
Vargas-Villagran, H:
Univ Nacl Autonoma Mexico, Inst Ciencias Fis, Lab Nanopolimerios & Coloides, Cuernavaca 62210, Morelos, Mexico
Romo-Uribe, A:
Univ Nacl Autonoma Mexico, Inst Ciencias Fis, Lab Nanopolimerios & Coloides, Cuernavaca 62210, Morelos, Mexico
Teran-Salgado, E:
Univ Nacl Autonoma Mexico, Inst Ciencias Fis, Lab Nanopolimerios & Coloides, Cuernavaca 62210, Morelos, Mexico
Dominguez-Diaz, M:
Univ Nacl Autonoma Mexico, Inst Ciencias Fis, Lab Nanopolimerios & Coloides, Cuernavaca 62210, Morelos, Mexico
|